How to take the print

Instructies

Stap 1: Mengen van de Componenten

  1. Verwijder de afsluitingen van beide componenten.
  2. Kneed beide componenten gedurende minstens 1 minuut samen.
  3. Zorg voor een gelijkmatige mix zonder klonten.
  4. Ga door met de volgende stap van het toepassingsproces

Stap 2: Toepassingsproces

  1. Breng de putty aan op het gewenste oppervlak en druk het stevig aan om een afdruk te maken.
  2. Verwijder de putty na een paar seconden voorzichtig zonder deze te vervormen.
  3. Laat de putty gedurende 5 minuten uitharden voordat verdere handelingen worden uitgevoerd.

Stap 3: Vorm uit laten harden en Verzenden

  1. Nadat de putty gedurende 5 minuten is uitgehard, controleer de hardheid door zachtjes met de vinger op de achterkant te drukken, waar geen afdruk is achtergelaten.
  2. Plaats de verkregen vorm terug in het bijgeleverde plastic zakje.
  3. Dit plastic zakje kan worden geretourneerd in de gefrankeerde bubbeltjesenvelop voor verdere verwerking.

Extra Instructies

  1. De uiteindelijke resultaat is afhankelijk van de kwaliteit en vorm van de afdruk.
  2. Eenmaal de siliconenputty is uitgehard, is het niet meer mogelijk om een afdruk te maken. U dient daarom vrij snel te werk te gaan.
  3. Als de eerste afdruk niet lukt, kunt u de putty opnieuw kneden en opnieuw proberen. Houd er echter rekening mee dat dit slechts een aantal keer kan worden herhaald.
  4. De meegeleverde hoeveelheid is voldoende voor het maken van één afdruk.

ENGLISH

Step 1: Mixing the Components

  1. Remove the seals from both components.
  2. Knead both components together for 30 seconds. (don’t over knead)
  3. Mix the components until they are uniformly blended and a consistent color is achieved.
  4. Proceed to the next step of the application process.

Step 2: Application Process

  1. Apply the putty to the desired surface and press firmly to create an impression.
  2. After a few seconds, carefully remove the putty without deforming it.
  3. Allow the putty to cure for 5 minutes before further handling.

Step 3: Curing the Mold and Shipping

  1. After the putty has cured for 5 minutes, check the hardness by gently pressing with a finger on the back where no impression was left.
  2. Place the obtained mold back into the provided plastic bag.
  3. Write the name of the captured print on the provided bag and assign the corresponding number based on your design choice
  4. This plastic bag can be returned in the pre-paid bubble envelope for further processing.

Additional Instructions

  1. The final result depends on the quality and shape of the impression.
  2. Once the silicone putty has cured, it is no longer possible to make an impression. Therefore, you should work fairly quickly.
  3. If the first impression is unsuccessful, you can knead and try the putty again. Keep in mind that this can only be repeated a few times.
  4. The quantity provided is suitable for creating one impression. If additional impressions are needed, please purchase additional kits accordingly.
  5. If using gloves, avoid using rubber gloves as they may affect the curing of the silicone. PVC gloves are recommended.
  6. To prevent choking hazards, please store this product out of the reach of children.
  7. While safe for handling, please be advised that this product is not suitable for consumption.